Navigation / Multi-Display

Voice recognition not possible

~1min read

PROCEDURE

  1. CHECK CONDITION

(a) Paying attention to the status of the voice command, perform a voice recognition operation.

OK:

The voice command is recognized normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the microphone icon. (Example: When "Cancel" is spoken, "Cancel" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "Hum" or "Ah") is spoken before or after the recognition word, the system will not recognize the recognition word correctly.
  • The system cannot recognize voice commands when multiple people speak at the same time.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the sound quality (such as a hoarse voice due to poor physical condition).
OK

END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SOUND CONDITION)

NG

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE