Noise present
PROCEDURE
CHECK THE CONDITIONS UNDER WHICH THE NOISE OCCURS
(a) Check the source of the noise (front left or front right, rear left or rear right).
OK:
The source of the noise can be determined.
| NG | GO TO STEP 3 |
|
CHECK THE SPEAKERS
(a) Check the installation condition of the speakers located near a noise source. Check for cracks, scratches, deformation or other problems.
Result:
Result | Proceed to |
|---|---|
No malfunction is detected. |
A |
A speaker is not installed properly. |
B |
Foreign matter is present in a speaker. |
C |
The speaker cone paper is damaged. |
D |
| B | REINSTALL THE SPEAKER |
| C | REMOVE THE FOREIGN MATTER |
| D | REPLACE THE SPEAKER |
|
CHECK THE CONDITIONS UNDER WHICH THE NOISE OCCURS
(a) Check the conditions under which the noise occurs.
HINT:
The radio is equipped with a noise suppression device to reduce noise during listening. When the noise is significant, check whether the antenna mount base ground and the noise suppression device unit are correctly installed and wired.
Conditions under which the noise occurs | Source of the noise |
|---|---|
The noise increases when the accelerator pedal is depressed, but stops when the engine is turned off. |
Generator |
The noise occurs while the A/C or heater is operating. |
Blower motor |
The noise occurs when the horn switch is pressed and released or held down. |
Horn |
The noise occurs in sync with the turn signal flashing. |
Turn signal |
The noise occurs while the washer is operating. |
Washer |
The noise occurs while the wipers are operating. |
Wiper |
The noise occurs when the brake pedal is depressed. |
Stop light switch |
Other |
Static electricity |
HINT:
- In the left column of the table, find the condition that matches the problem described by the customer. Then, in the right column, find the part causing the noise. Check the corresponding noise filter.
- To save time and avoid a misdiagnosis, first make sure that the noise does not come from outside the vehicle.
- Troubleshoot starting with the loudest noises.
- Finding the source of the noise is easier if the radio is tuned to a frequency where no signal is received.
Result:
Result | Proceed to |
|---|---|
The source of the noise cannot be determined. |
A |
The source of the noise can be determined |
B |
| A | GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE |
| B | REPAIR OR REPLACE THE PART CAUSING THE NOISE |