Touch screen buttons do not operate
PRECAUTION / NOTICE / HINT
NOTICE:
- Depending on the parts replaced during vehicle inspection or maintenance, initialization, registration or calibration may be required. Refer to the precautions for the navigation system.
Click here
.gif)
- When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly that was installed in another vehicle is reused, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
PROCEDURE
CHECK MULTI-DISPLAY
(a) Make sure that no foreign matter is caught between the screen and the outer frame of the multi-display.
OK:
No foreign matter is caught between the screen and the outer frame of the multi-display.
HINT:
- If foreign matter is caught between the screen and the outer frame of the multi-display, the touch screen remains stuck, preventing touch switch operation.
- Turn the ignition switch to ON (ACC) or ON (IG) while touching the operating section with your hand; no response may occur.
| NG | REMOVE THE FOREIGN MATTER |
|
CHECK TOUCH SCREEN
(a) Check that there is no foreign matter on the display.
OK:
The screen is clean.
| NG | CLEAN THE SCREEN AND CHECK THE TOUCH SWITCHES AGAIN |
|
CHECK TOUCH SWITCH (FUNCTION CHECK)
(a) Select the "Touch Switch Check" screen. Refer to Touch Switch Check in the Function Check. Click here |
![]() |
(b) Touch the screen where the defective switch is located.
OK:
A "+" mark appears at the touched location.
| OK | REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
| NG | GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE |
.png)