Navigation / Multi-Display

Reverse Signal Circuit

~3min read

DESCRIPTION

The Audio and Display System Assembly receives a reverse signal from the Park/Neutral Position Switch.

WIRING DIAGRAM

PROCEDURE

  1. CHECK VEHICLE SIGNAL (OPERATION CHECK)

(a) Select the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (click here) ).

(b) Check that the display switches between ON and OFF depending on the shift lever position.

HINT:

This screen is updated every second. Therefore, it is normal for the display to lag behind the actual shift lever position.

OK:

Shift lever position

Display

R

ON

Except R

OFF

ON

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

OFF
  1. CHECK RADIO AND DISPLAY SYSTEM

(a) Disconnect the radio receiver and display assembly connector.

*a

Front view of wire harness side connector

(to radio receiver and display assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Ignition switch position

Specified Condition

F129-28 (REV) - Body Ground

Ignition switch ON (IG), shift lever in R position

7,5 à 14 V

F129-28 (REV) - Body Ground

Ignition switch ON (IG), shift lever in position other than R

Below 1 V

OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG
  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)

(a) Disconnect connector F129 from the radio receiver and display assembly.

(b) Disconnect the C36 connector from the park/neutral position switch.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F129-28 (REV) - C36-2 (RL)

Always

Below 1 Ω

F129-28 (REV) - Body Ground

Always

10 kΩ minimum

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

OK
  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)

(a) Disconnect the park/neutral position switch connector.

*a

Front view of wire harness side connector

(to park/neutral position switch)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Ignition switch position

Specified Condition

C36-1 (RB) - Body ground

Engine switch in ON (IG) position

11 à 14 V

OK

REPLACE PARK/NEUTRAL POSITION SWITCH

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR