Navigation / Multi-Display

Illumination Circuit

~3min read

DESCRIPTION

Power is supplied to the illumination of the radio receiver and display assembly and the steering pad switch assembly when the light control switch is in the TAIL or HEAD position.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • This vehicle is equipped with a Supplemental Restraint System (SRS) including components such as airbags. Before performing any service (including removal or installation of parts), carefully read the precautions for the Supplemental Restraint System.

    Click here

  • Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK ILLUMINATION

(a) Check whether the illumination of the radio receiver and display assembly, steering pad switch assembly, heater control switch or others (hazard switch, transmission control switch, etc.) lights up when the light control switch is set to the HEAD or TAIL position.

Result:

Result

Proceed to

The illumination lights up for all components except the steering pad switch assembly.

A

All components light up except the radio receiver and display assembly.

B

No illumination (radio receiver and display assembly, hazard switch, heater control switch, etc.) lights up.

C

B

GO TO STEP 5

C

GO TO ILLUMINATION SYSTEM

A
  1. CHECK WIRE HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

(a) Disconnect connector F29 from the spiral cable sub-assembly.

*a

Front view of wire harness side connector

(to steering pad switch assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F29-13 (IL+2) - Body ground

Light control switch in TAIL or HEAD position

11 à 14 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK STEERING PAD SWITCH ASSEMBLY

(a) Remove the steering pad switch assembly.

Click here

(b) Check the steering pad switch assembly.

Click here

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

OK
  1. CHECK SPIRAL CABLE SUB-ASSEMBLY

(a) Remove the spiral cable sub-assembly.

Click here

(b) Inspect the spiral cable sub-assembly.

Click here

OK

REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY, COMBINATION METER ASSEMBLY)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

  1. CHECK WIRE HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

(a) Disconnect the radio receiver and display assembly connector.

*a

Front view of wire harness side connector

(to radio receiver and display assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F131-15 (ILL+) - Body ground

Light control switch in TAIL or HEAD position

11 à 14 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK WIRE HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)

(a) Disconnect the F131 connector from the radio and display receiver assembly.

(b) Disconnect the combination meter assembly connector F4.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F131-16 (ILL-) - F4-38 (ILL-)

Always

Below 1 Ω

F131-16 (ILL-) or F4-38 (ILL-) - Body ground

Always

10 kΩ minimum

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR