Navigation / Multi-Display

Radio Receiver Power Supply Circuit

~1min read

DESCRIPTION

This is the power supply circuit that operates the Radio Receiver and Display Assembly.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY POWER SOURCE - RECEIVER ASSEMBLY)

(a) Disconnect the F129 and F131 connectors from the radio and display receiver assembly.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F129-1 (GND1) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Ignition switch position

Specified Condition

F129-4 (+B1) - F129-1 (GND1)

Always

11 à 14 V

F129-15 (ACC1) - F129-1 (GND1)

Engine switch in ON (ACC) position

11 à 14 V

F131-19 (IG) - F129-1 (GND1)

Engine switch in ON (IG) position

11 à 14 V

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR