Navigation / Multi-Display

USB Device Malfunction (B1585)

~3min read

DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B1585

USB Device Malfunction

USB Device Malfunction

  • Storage class other than mass storage or USB device with incompatible protocol
  • USB device with incompatible file system, or corrupted or incompatible file allocation table
  • "iPod" Malfunction
  • "iPod" with unsupported firmware
  • Unsupported "iPod" model
  • USB Device or "iPod"
  • Radio and Display Receiver Assembly
DTC Detection Conditions

Vehicle Operating Conditions

Sequence 1

Sequence 2

Sequence 3

Sequence 4

Sequence 5

Diagnostic Condition

-

-

-

-

-

-

Malfunction Status

A USB device with a storage class other than mass storage, or with an incompatible protocol, is connected

○

-

-

-

-

A USB device with an incompatible file system, or a corrupted or incompatible file allocation table, is connected

-

○

-

-

-

"iPod" Malfunction

-

-

○

-

-

An "iPod" with unsupported firmware is connected

-

-

-

○

-

An unsupported "iPod" model is connected

-

-

-

-

○

Detection Duration

-

-

-

-

-

Number of Trips

1 trip(s)

1 trip(s)

1 trip(s)

1 trip(s)

1 trip(s)

HINT:

The DTC is output when the conditions for any one of the sequences in the table above are met.

PRECAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts replaced during vehicle inspection or maintenance, initialization, registration or calibration may be required. Refer to the precautions for the navigation system.

    Click here

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly that was installed in another vehicle is reused, the following may occur:
    • A communication malfunction DTC is stored.
    • The radio and display receiver assembly may not operate normally.

PROCEDURE

  1. REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

(b) Turn the engine switch off.

HINT:

When this DTC has been stored, the ignition switch must be turned OFF so that the vehicle can recognize a new device when it is connected.

(c) Turn the ignition switch to ON (ACC).

(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:

  • If the malfunction occurred while a USB device was being used, use a different USB device to perform the check. If the malfunction occurred while an "iPod" was being used, use a different "iPod" to perform the check.
  • Refer to the System Description section for compatible formats and versions.

    Click here

NEXT
  1. CHECK DTCs

(a) Clear the DTCs.

Click here

Body Electrical > Navigation System > Clear DTCs

(b) Check DTCs again and confirm that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTC is output.

OK

INCOMPATIBLE USB DEVICE FORMAT, INCOMPATIBLE "iPod" VERSION, OR MALFUNCTIONING USB DEVICE OR "iPod"

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY