Navigation / Multi-Display

Loss of Communication with Combination Meter (B1324)

~3min read

DESCRIPTION

This DTC is stored when a communication error occurs between the radio and display assembly and the combination meter assembly.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B1324

Loss of communication with combination meter

After the radio and display receiver assembly receives a recording information signal sent by the instrument cluster assembly when the ignition switch is turned to ON (ACC) at least once, the radio and display receiver assembly does not receive the signal for at least 30 seconds.

  • Combination meter assembly
  • Radio and Display Receiver Assembly
  • Wire harness or connector

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts replaced during vehicle inspection or maintenance, initialization, registration or calibration may be required. Refer to the precautions for the navigation system.

    Click here

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly that was installed in another vehicle is reused, the following may occur:
    • A communication malfunction DTC is stored.
    • The radio and display receiver assembly or navigation ECU may not operate correctly.
  • When replacing the instrument cluster assembly, always use a new part. If an instrument cluster assembly that was installed in another vehicle is used, the stored information will not match the information transmitted by the vehicle, and a DTC may be stored.

PROCEDURE

  1. CHECK DTCs (METER/GAUGE SYSTEM)

(a) Clear the DTCs.

Body Electrical > Combination Meter > Clear DTCs

(b) Check DTCs again and confirm that no DTCs are output.

Body Electrical > Combination Meter > Trouble Codes

OK:

No DTC is output.

NG

GO TO METER/GAUGE SYSTEM

OK
  1. CHECK WIRE HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)

(a) Disconnect the F131 connector from the radio and display receiver assembly.

(b) Disconnect the combination meter assembly connector F4.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F131-5 (CNH1) - F4-36 (MSCH)

Always

Below 1 Ω

F131-6 (CNL1) - F4-37 (MSCL)

Always

Below 1 Ω

F131-5 (CNH1) - Body ground

Always

10 kΩ minimum

F131-6 (CNL1) - Body ground

Always

10 kΩ minimum

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. REPLACE COMBINATION METER ASSEMBLY

(a) Replace the combination meter assembly.

Click here

(b) Clear the DTCs.

Click here

Body Electrical > Navigation System > Clear DTCs

(c) Check DTCs again and confirm that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTC is output.

OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY