Navigation / Multi-Display

The "No GPS signal" icon is displayed

~2min read

PRECAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts replaced during vehicle inspection or maintenance, initialization, registration or calibration may be required. Refer to the precautions for the navigation system.

    Click here

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly that was installed in another vehicle is reused, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.

PROCEDURE

  1. CHECK INTERIOR

(a) Make sure there are no objects in the cabin on the instrument panel that could interfere with radio reception or other devices that use radio waves. If an object is found, remove it and check whether the "No GPS signal" indicator goes off.

HINT:

GPS works using extremely weak radio waves generated by satellites. If the signal is blocked by obstacles or other radio waves, the GPS system may not receive it properly.

OK:

The "No GPS signal" indicator goes off.

OK

END

NG
  1. CHECK SURROUNDINGS

(a) Check whether the vehicle is in a location with poor GPS signal reception. If so, move the vehicle and check whether the "No GPS signal" indicator goes off.

HINT:

The GPS system uses 24 satellites placed in 6 orbits. At all times, 4 satellites must be able to locate the vehicle. However, GPS signals may be unable to reach the vehicle due to factors such as the environment, the vehicle's direction, or the time of day. For examples, refer to the following illustration.

*a

Example

*b

In a tunnel

*c

In a building

*d

Under an overpass

*e

In a forest or on a tree-lined road

*f

Between tall buildings

*g

Under a cliff or overhang

-

-

OK:

The "No GPS signal" indicator goes off.

OK

THE SYSTEM RETURNS TO NORMAL

NG
  1. CHECK GPS INFORMATION (OPERATION CHECK)

(a) Go to the "System Sensors Check" screen. Refer to Check GPS & Vehicle Sensors in Operation Check.

Click here

(b) Check the number of the following codes shown in the "Reception number" column.

HINT:

T or P is displayed.

OK:

At least 3 codes are displayed.

OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE