Honda Accord Quiz
Body

Rear Bumper Cover Removal and Installation

In this manual: Body
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

The vehicles covered in this Manual are equipped with a Supplemental Restraint System (SRS). Before performing any work near the airbag module, steering column, or instrument panel, disable the SRS to prevent injury from accidental deployment (see Section Body Electrical System). SRS wiring can be easily identified by its yellow insulation.

PROCEDURE

1. If necessary, raise the rear of the vehicle and support it on stands.

2. Под автомобилем извлеките пластмассовые фиксаторы крепления нижнего края накладки

2. Under the vehicle, remove the plastic retainers securing the lower edge of the rear bumper cover.

3. Выверните болт и отпустите фиксатор крепления каждого из концов накладки к

3. Remove the bolt and release the retainer securing each end of the cover to the rear wheel arches.

4. Откройте крышку багажника и изнутри багажного отделения отпустите фиксаторы

4. Open the luggage compartment lid and release the retainers securing the upper edge of the bumper cover from inside the luggage compartment.

Use a small screwdriver to pry up the center sections of the plastic retainers (do not attempt to fully remove the center sections - they remain in the retainer). Remove the cover from the vehicle.
5. Install in the reverse order of removal.

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.