Window Regulator Removal and Installation

Wear gloves to protect your hands from cuts when performing procedures through the access holes in the door frame.
Front Doors
PROCEDURE

1. Remove the door trim panel and water shield (refer to Door Trim Panel Removal and Installation).
2. Remove the window glass (refer to Door Glass Removal and Installation).
3. On models equipped with power windows, disconnect the wiring connector from the regulator drive motor.
4. Remove the mounting bolts of the window regulator/power motor assembly.

5. Coupe models use scissor-type regulators. Before removing the mounting bolts, mark the position of the rear bolt of the upper roller guide. Remove the bolts of the upper and rear roller guides, then remove the four power motor mounting bolts (on models with manual operation, the window crank).
6. Remove the equalizer arm and regulator assemblies through the special opening in the door frame.
7. Installation is the reverse of removal. Be sure to lubricate the guide rollers and the regulator sliding surfaces.

Rear Doors
PROCEDURE

1. Remove the door trim panel and water shield (refer to Door Trim Panel Removal and Installation).
2. Remove the window glass (refer to Door Glass Removal and Installation).
3. On models equipped with power windows, disconnect the wiring connector from the regulator drive motor.

4. Remove the mounting bolts of the window regulator/power motor assembly.

5. Remove the equalizer arm and regulator assemblies through the special opening in the door frame.
6. Installation is the reverse of removal. Be sure to lubricate the guide rollers and the regulator sliding surfaces.