Honda Accord Quiz
Body

Front Fender Removal and Installation

In this manual: Body
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

PROCEDURE

1. Loosen the wheel nuts of the respective front wheel. Raise the front of the vehicle and support it on stands. Remove the wheel.
2. Remove the front bumper cover (see Section Front and Rear Bumper Cover Removal and Installation).

3. Выверните крепежные винты, отпустите фиксаторы и снимите локер защиты арки

3. Remove the mounting screws, release the retainers and remove the wheel arch splash shield with the rubber mud flap.

4. Откройте переднюю дверь и выверните верхний болт крепления задней части крыла

4. Open the front door and remove the upper bolt securing the rear part of the fender to the body.

5. Remove the mounting screws and remove the outer plastic sill protector to gain access to the lower bolt securing the rear part of the fender.

6. Выверните оставшийся крепеж.

6. Remove the remaining fasteners.

7. Отдайте оставшиеся болты крепления крыла.

7. Remove the remaining fender bolts.

8. Remove the fender (it is advisable to use an assistant to minimize the risk of damaging the surrounding body panels).
9. Install in the reverse order of removal.

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.