Honda Accord Quiz
Body

Removal and Installation of Instrument Panel Trim Sections - Center Section

In this manual: Body
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

PROCEDURE

1. Поддев обмотанной скотчем отверткой, снимите облицовку сборки панельных часов.

1. Using a screwdriver wrapped with tape, pry off the clock assembly trim.

2. After releasing the trim, disconnect the wiring connectors of the clock and the hazard warning switch.

3. Выверните винты крепления центральной секции панели приборов. Один из винтов

3. Remove the screws securing the center section of the instrument panel. One screw is located in the upper recess for the clock trim, two are at the bottom. The remaining part of the panel is secured by plastic clips.

4. Панель управления функционированием отопителя/кондиционера воздуха крепится

4. The heater/air conditioner control panel is attached to the instrument panel with screws installed from the rear. Release the panel from its seat, disconnect the wiring and remove the assembly.

5. Installation is the reverse of removal.

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.