Engine

Electrical Load Signal

3steps
~18min
2/5difficulty
Done 0 of 3
Component Function Check

CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION

  1. Turn ignition switch ON.

  2. Connect CONSULT and select “DATA MONITOR” mode.

  3. Select “LOAD SIGNAL” and check indication under the following conditions.

    Monitor itemConditionIndication
    LOAD SIGNAL Rear window defogger switch ON ON
    OFF OFF

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Proceed to Diagnosis Procedure.

CHECK LIGHTING SWITCH FUNCTION

Check “LOAD SIGNAL” indication under the following conditions.

Monitor itemConditionIndication
LOAD SIGNAL Lighting switch ON at 2nd position ON
OFF OFF

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Proceed to Diagnosis Procedure.

CHECK HEATER FAN CONTROL SWITCH FUNCTION

Select “HEATER FAN SW” and check indication under the following conditions.

Monitor itemConditionIndication
HEATER FAN SW Heater fan control switch ON ON
OFF OFF

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Proceed to Diagnosis Procedure.

Diagnosis Procedure

The electrical load signal (Headlamp switch signal, rear window defogger switch signal, etc.) is transferred via the CAN communication.

INSPECTION START

Confirm the malfunctioning circuit (rear window defogger, headlamp or heater fan). Refer to Component Function Check.

Which circuit is related to the incident?

Rear window defogger>>

GO TO 2.

Headlamp>>

GO TO 3.

Heater fan>>

GO TO 4.

CHECK REAR WINDOW DEFOGGER SYSTEM

Check rear window defogger system. Refer to Work Flow.

>>

INSPECTION END

CHECK HEADLAMP SYSTEM

Check headlamp system. Refer to Work Flow.

>>

INSPECTION END

CHECK HEATER FAN CONTROL SYSTEM

Check heater fan control system. Refer to Work Flow.

>>

INSPECTION END