Engine

P0107 Barometric Pressure Sensor

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detecting conditionPossible cause
P0107

ABSL PRES SEN/CIRC

(Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Low)
An excessively low voltage from the sensor is sent to ECM. Barometric pressure sensor (built-into ECM)

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and let it idle for 5 seconds.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to Diagnosis Procedure.

NO>>

INSPECTION END

Diagnosis Procedure

DTC CONFIRMATION

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure. Refer to DTC Description.

  4. Check the DTC.

Is the DTC displayed again?

YES>>

Replace ECM. Refer to Removal and Installation.

NO>>

INSPECTION END