Engine

P0532 Refrigerant Pressure Sensor

8steps
~48min
3/5difficulty
Done 0 of 8
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detecting condition
P0532

REFRIGERANT PRESS SENSOR A

(A/C refrigerant pressure sensor A circuit low)
Diagnosis condition
  • Ignition switch ON

  • Engine running

Signal (terminal) Refrigerant pressure sensor signal
Threshold ECM detects that input signal from the refrigerant pressure sensor is out of the specified range.
Diagnosis delay time 5 seconds or more

POSSIBLE CAUSE

  • Harness or connectors

  • Refrigerant pressure sensor

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

DTC CONFIRMATION PROCEDURE

PRECONDITIONING- 1

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more under ignition switch OFF condition.

>>

GO TO 2.

PRECONDITIONING- 2

Check the following conditions:

Ambient temperature 0 °C or more

Is the condition satisfied?

YES>>

GO TO 3.

NO>>
  1. Satisfy the condition.

  2. GO TO 3.

PERFORM COMPONENT FUNCTION CHECK

Perform component function check. Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Refer to DTC Diagnosis Procedure.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and warm it up to normal operating temperature.

  2. Hold Nissan Murano vehicle speed at more than 40 km/h for 180 consecutive seconds.

  3. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

INSPECTION END

DTC Diagnosis Procedure

CHECK REFRIGERANT PRESSURE SENSOR

Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace refrigerant pressure sensor. Refer to Removal and Installation.