P0112 Iat Sensor
DTC DETECTION LOGIC
An excessively low voltage from the sensor is sent to ECM.
An excessively high voltage from the sensor is sent to ECM.
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | |
| P0112 | IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit low bank 1) |
Diagnosis condition | Ignition switch ON |
| Signal (terminal) | Voltage signal transmitted from intake air temperature sensor to ECM | ||
| Threshold | An excessively low voltage from the sensor is sent to ECM | ||
| Diagnosis delay time | — | ||
| P0113 | IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit high bank 1) |
Diagnosis condition | Ignition switch ON |
| Signal (terminal) | Voltage signal transmitted from intake air temperature sensor to ECM | ||
| Threshold | An excessively high voltage from the sensor is sent to ECM | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
P0112
Harness and connectors (The sensor circuit is open or shorted.)
Intake air temperature sensor
P0113
Harness and connectors (The sensor circuit is open or shorted.)
Intake air temperature sensor
FAIL-SAFE
Not applicable
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
Turn ignition switch ON and wait at least 5 seconds.
Check 1st trip DTC.
Is 1st trip DTC detected?
YES>>Proceed to Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: INSPECTION END
CHECK INTAKE AIR TEMPERATURE SENSOR POWER SUPPLY
Disconnect mass air flow sensor (with intake air temperature sensor) harness connector.
Ignition switch ON.
Check the voltage between mass air flow sensor harness connector and ground.
MAF sensor Ground Voltage
(Approx.)Connector Terminal F94 4 Ground Approx. 5 V
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair open circuit, short to ground or short to power in harness or connectors.
CHECK INTAKE AIR TEMPERATURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
Ignition switch OFF.
Disconnect ECM harness connector.
Check harness continuity between mass air flow sensor harness connector and ECM harness connector.
MAF sensor ECM Continuity Connector Terminal Connector Terminal F94 3 F78 40 Existed Also check harness for short to ground and short to power.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair open circuit, short to ground or short to power in harness or connectors.
CHECK INTAKE AIR TEMPERATURE SENSOR
Check intake air temperature sensor. Refer to Component Inspection.
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace mass air flow sensor. Refer to Removal and Installation.
CHECK INTAKE AIR TEMPERATURE SENSOR
Turn ignition switch OFF.
Disconnect mass air flow sensor harness connector and reconnect it again.
Turn ignition switch ON.
On CONSULT screen, select “ENGINE” >> “DATA MONITOR” >> “INT/A TEMP SEN”.
Check that the indicated value of “INT/A TEMP SEN” is almost the same as intake air temperature.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Replace mass air flow sensor. Refer to Removal and Installation.