Engine
P1148 Closed Loop Control
In this manual: Engine
~1min read
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | |
| P1148 | CLOSED LOOP-B1 (Closed loop bank 1) |
Diagnosis condition | — |
| Signal (terminal) | — | ||
| Threshold | The closed loop control function for bank 1 does not operate even when Nissan Murano vehicle is being driven in the specified condition | ||
| Diagnosis delay time | — | ||
| P1168 | CLOSED LOOP-B2 (Closed loop bank 2) |
Diagnosis condition | — |
| Signal (terminal) | — | ||
| Threshold | The closed loop control function for bank 2 does not operate even when Nissan Murano vehicle is being driven in the specified condition | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
Harness or connectors
(The A/F sensor 1 circuit is open or shorted.)
A/F sensor 1
A/F sensor 1 heater
FAIL-SAFE
Not applicable
CHECK DTC PRIORITY
If DTC P1148 or P1168 is displayed with another DTC for A/F sensor 1, perform the trouble diagnosis for the corresponding DTC.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>INSPECTION END
Was this page helpful?