Engine

U1044 Eng Comm Circuit

10steps
~60min
3/5difficulty
Done 0 of 10
DTC Description

DTC DETECTION LOGIC

A signal voltage of LIN communication between ECM and generator is excessively low or excessively high.

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U1044

ENG COMM CIRCUIT

(Engine communication circuit)
Diagnosis condition Ignition switch ON
Signal (terminal) Signal voltage of LIN communication
Threshold Signal voltage between ECM and generator is excessively low or excessively high
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors

    (LIN communication circuit is open or shorted.)

  • Generator

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted. always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition ON and wait at least 10 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK ACTIVE GRILLE SHUTTER SIGNAL CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connector.

  3. Disconnect active grille shutter harness connector.

  4. Check the continuity between ECM harness connector and active grille shutter harness connector.

    +−Continuity
    ECMActive grille shutter
    ConnectorTerminalConnectorTerminal
    F79 99 E238 3 Existed
  5. Also check harness for short to ground and short to power.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Repair or replace error-detected parts.