Engine

P0315 Crankshaft Position

5steps
~30min
2/5difficulty
Done 0 of 5
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P0315

Crankshaft position

(Crankshaft Position System Variation Not Learned)
Diagnosis condition Engine run and fuel shut off
Signal —
Threshold Learning value of signal plate variation is abnormal or not learned.
Diagnosis delay time —

POSSIBLE CAUSE

  • Signal plate

  • Crankshaft position sensor

  • Harness or connectors (Crankshaft position sensor circuit is open or shorted.)

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC P0315 is displayed with DTC P0335, first perform the trouble diagnosis for DTC P0335.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. DTC Index.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine and warm it up to normal operating temperature.

  2. Drive Nissan Murano vehicle at 80 km/h, with selecting suitable gear.

  3. Release accelerator pedal completely to decelerate the Nissan Murano vehicle.

  4. Repeat the step 2 and 3 until the integrated deceleration time to be 30 seconds.

  5. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK DTC PRIORITY

If DTC P0315 is displayed with DTC P0335, first perform the trouble diagnosis for DTC P0335.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2.

CHECK GEAR TOOTH

Visually check for chipping signal plate gear tooth.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace the signal plate. Refer to Exploded View.