Engine

Sensor Power Supply2 Circuit

7steps
~42min
2/5difficulty
Done 0 of 7
Diagnosis Procedure

ECM supplies a voltage of 5 V to some of the sensors systematically divided into 2 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the short-circuited sensor.

Sensor power supply 1

  • Accelerator pedal position (APP) sensor 1

  • Crankshaft position (CKP) sensor (POS)

  • Exhaust valve timing (EVT) control position sensor

  • Mass air flow (MAF) sensor

  • Throttle position (TP) sensor

Sensor power supply 2

  • Accelerator pedal position (APP) sensor 2

  • Camshaft position (CMP) sensor (PHASE)

  • Engine oil pressure (EOP) sensor

  • Refrigerant pressure sensor

CHECK SENSOR POWER SUPPLY 2

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connectors

  3. Turn ignition switch ON.

  4. Check the voltage between ECM harness connector and ground.

    +−

    Voltage

    (Approx.)
    ECM
    ConnectorTerminal
    E32 142 Ground 5 V
    F78 18
    F79 92

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

GO TO 2.

CHECK SENSOR POWER SUPPLY 2 CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect following sensors harness connector.

  3. Check harness for short to power and short to ground, between the following terminals.

ECMSensor
ConnectorTerminalNameConnectorTerminal
E32 142 APP sensor 2 E31 5
F78 18 Refrigerant pressure sensor E244 1
EOP sensor F87 3
F79 92 CMP sensor (PHASE) (bank 1) F77 1
CMP sensor (PHASE) (bank 2) F60 1

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK COMPONENTS

Check the following.

  • Accelerator pedal position (APP) sensor 2 (Refer to Component Inspection.)

  • Camshaft position sensor (PHASE) (bank 1) (Refer to Component Inspection.)

  • Camshaft position sensor (PHASE) (bank 2) (Refer to Component Inspection.)

  • Engine oil pressure (EOP) sensor (Refer to Component Inspection.)

  • Refrigerant pressure sensor (Refer to Diagnosis Procedure.)

Is the inspection result normal?

YES>>

Perform Intermittent Incident.

NO>>

Replace malfunctioning component.