Engine

P1574 Ascd Vehicle Speed Sensor

6steps
~36min
2/5difficulty
Done 0 of 6
DTC Description

DESCRIPTION

The ECM receives two vehicle speed signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to System Description for ASCD functions.

DTC DETECTION LOGIC

The difference the between two vehicle speed signals is out of the specified range.

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P1574

ASCD VHL SPD SEN

(ASCD Nissan Murano vehicle speed sensor)
Diagnosis condition Start engine and drive the Nissan Murano vehicle at more than 40 km/h
Signal (terminal) —
Threshold The difference the between two Nissan Murano vehicle speed signals is out of the specified range
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors

    (The CAN communication line is open or shorted.)

  • Combination meter

  • ABS actuator and electric unit (control unit)

  • Wheel sensor

  • TCM

  • ECM

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC P1574 is displayed with DTC UXXXX, P0500, P0605 or P0607, first perform the confirmation procedure for DTC UXXXX, P0500, P0605 or P0607.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC UXXXX: Refer to DTC Index.

  • DTC P0500: Refer to DTC Description.

  • DTC P0605: Refer to DTC Description.

  • DTC P0607: Refer to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine (VDC switch OFF).

  2. Drive the Nissan Murano vehicle at more than 40 km/h.

  3. Check DTC.

Is DTC detected?

YES>>

Proceed to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC P1574 is displayed with DTC UXXXX, P0500, P0605 or P0607, first perform the confirmation procedure for DTC UXXXX, P0500, P0605 or P0607.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC UXXXX: Refer to DTC Index.

  • DTC P0500: Refer to DTC Description.

  • DTC P0605: Refer to DTC Description.

  • DTC P0607: Refer to DTC Description.

NO>>

GO TO 2.

CHECK DTC WITH TCM

Check DTC with TCM. Refer to CONSULT Function.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Perform trouble shooting relevant to DTC indicated.

CHECK DTC WITH ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Check DTC with ABS actuator and electric unit (control unit). Refer to CONSULT Function.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace malfunctioning part.

CHECK COMBINATION METER FUNCTION

Check combination meter function. Refer to CONSULT Function (METER/MA).

>>

INSPECTION END