Engine

P0462 Fuel Level Sensor

5steps
~30min
2/5difficulty
Done 0 of 5
DTC Description

DTC DETECTION LOGIC

  • An excessively low voltage from the sensor is sent to ECM.

  • An excessively high voltage from the sensor is sent to ECM.

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P0462

FUEL LEVL SEN/CIRC

(Fuel level sensor “A” circuit low)
Diagnosis condition Ignition switch ON
Signal (terminal) Voltage signal transmitted from fuel level sensor to ECM
Threshold An excessively low voltage from the sensor is sent to ECM
Diagnosis delay time —
P0463

FUEL LEVL SEN/CIRC

(Fuel level sensor “A” circuit high)
Diagnosis condition Ignition switch ON
Signal (terminal) Voltage signal transmitted from fuel level sensor to ECM
Threshold An excessively high voltage from the sensor is sent to ECM
Diagnosis delay time —

POSSIBLE CAUSE

DTC P0462

  • Harness or connectors

    (The CAN communication line is open or shorted)

  • Harness or connectors

    (The sensor circuit is open or shorted)

  • Combination meter

  • Fuel level sensor

DTC P0463

  • Harness or connectors

    (The CAN communication line is open or shorted)

  • Harness or connectors

    (The sensor circuit is open or shorted)

  • Combination meter

  • Fuel level sensor

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC P0462 or P0463 is displayed with DTC UXXXX or P0607, first perform the confirmation procedure for DTC UXXXX or P0607.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC UXXXX: Refer to DTC Index.

  • DTC P0607: Refer to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at ignition switch ON.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 5 seconds.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC P0462 or P0463 is displayed with DTC UXXXX or P0607, first perform the confirmation procedure for DTC UXXXX or P0607.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC UXXXX: Refer to DTC Index.

  • DTC P0607: Refer to DTC Description.

NO>>

GO TO 2.

CHECK COMBINATION METER FUNCTION

Check combination meter function. Refer to CONSULT Function (METER/MA).

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Proceed to Diagnosis Procedure.