Fiat Bravo Quiz
Electrical system

Removing and Installing the Connector Strip / Hazard Warning Switch

In this manual: Electrical system
Dear Reader — 1Engine — 35Engine lubrication — 3Engine cooling — 10Ignition/spark plugs — 14Fuel system — 10Petrol fuel injection — 13Diesel injection system — 13Exhaust system — 7Clutch — 7Transmission / Gearshift / Automatic Transmission — 5Front Axle — 11Rear axle — 4Steering — 9Wheel alignment — 1Brake system — 22Wheels and tyres — 10Body — 34Heating — 6Electrical system — 39Lighting system — 14Instruments — 7Windscreen wiper system — 8Vehicle care / tools — 6Jump Starting / Towing the Vehicle — 3Jacking up the vehicle — 1Fiat Bravo / Brava Maintenance Schedule — 1Maintenance — 38Wiring diagrams — 5
~1min read
Removal
Steckerleiste/warnblinkschalter aus- und einbauen

  • Pry off the side panels - 1 - with a small screwdriver.

    Place paper padding or a cloth underneath to avoid damaging the trim.

  • Unscrew the underlying hex socket screws (arrows) with a 3 mm Allen key. 4 - Blower switch.

Steckerleiste/warnblinkschalter aus- und einbauen

  • Remove the connector strip - 2 - and disconnect the plug connection.

  • Pry out the hazard warning switch - 3 - with a small screwdriver.

    Place paper padding or a cloth underneath to avoid damaging the trim.

  • Disconnect the multi-pin connector.

Installation

  • Plug the multiple connector onto the hazard warning switch, press the switch into the intended opening until it engages.

  • Connect the electrical wires to the connector strip.

  • Insert the connector strip and screw it on.

  • Press the side panels on.

Test yourself

A quick Fiat Bravo quiz: every answer comes with an explanation and a link to the manual page.