Exterior Lighting

Turn signal switch circuit

~2min read

DESCRIPTION

The combination meter assembly receives the turn signal switch information and controls the turn signal lights.

WIRING DIAGRAM

PROCEDURE

  1. CHECK VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menus: Body Electrical / Combination Meter / Data List.

(e) Read the Data List by following the instructions on the Techstream.

Body Electrical > Combination Meter > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

Turn Signal Switch (Right)

Turn signal switch (right) signal

ON or OFF

ON: Right turn signal switch in ON position

OFF: Right turn signal switch in OFF position

-

Turn Signal Switch (Left)

Turn signal switch (left) signal

ON or OFF

ON: Left turn signal switch in ON position

OFF: Left turn signal switch in OFF position

-

Turn Switch Signal (Full Turn)

Turn signal switch signal (full turn)

ON or OFF

ON: Turn signal switch (left or right) in ON position

OFF: Turn signal switch (left and right) in OFF position

-

Body Electrical > Combination Meter > Data List

Tester display

Turn Signal Switch (Right)

Turn Signal Switch (Left)

Turn Switch Signal (Full Turn)

OK:

The normal conditions listed above are displayed.

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG
  1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY

(a) Remove the headlight dimmer switch assembly.

Click here

(b) Inspect the headlight dimmer switch assembly.

Click here

NG

REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY

OK
  1. INSPECT WIRE HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY OR BODY GROUND)

(a) Disconnect the F5 combination meter assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F24-12 (TR) - F5-9 (ER)

Always

Below 1 Ω

F24-11 (TL) - F5-10 (EL)

Always

Below 1 Ω

F24-13 (CR) - F5-8 (SW)

Always

Below 1 Ω

F24-12 (TR) or F5-9 (ER) - Body ground

Always

10 kΩ minimum

F24-11 (TL) or F5-10 (EL) - Body ground

Always

10 kΩ minimum

F24-13 (CR) or F5-8 (SW) - Body ground

Always

10 kΩ minimum

F24-15 (EL) - Body ground

Always

Below 1 Ω

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR