Exterior Lighting

Left headlight circuit (B2439,B243A)

~3min read

DESCRIPTION

A DTC is stored when the headlight ECU subassembly receives a malfunction signal from the light source transmitted by its respective headlight unit. The left headlight ECU subassembly stores DTC B2439 or B243A.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Note

B2439

Left headlight circuit

Left headlight ECU subassembly light source malfunction

  • Left headlight unit assembly
  • Left Headlight ECU Subassembly

-

B243A

Right headlight circuit

Right headlight ECU subassembly light source malfunction

  • Right headlight unit assembly
  • Right headlight ECU sub-assembly

-

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

If the left headlight ECU subassembly has been replaced, it is necessary to synchronize the vehicle information and reset the left headlight ECU subassembly.

Click here

PROCEDURE

  1. CLEAR DTCs

(a) Clear the DTCs.

Click here

Body Electrical > HL AutoLeveling > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Turn the ignition switch to ON.

(b) Operate the light control switch to turn on the low beam headlights.

(c) Check the DTCs.

Click here

Body Electrical > HL AutoLeveling > Trouble Codes

OK:

DTCs B2439 and B243A are not output.

Result:

Result

Proceed to

OK

A

NG (DTC B2439 is output)

B

NG (DTC B243A is output)

C

A

USE SIMULATION METHOD TO CHECK

C

GO TO STEP 6

B
  1. REPLACE LEFT HEADLIGHT UNIT ASSEMBLY

(a) Replace the left headlight unit assembly with a new or normally functioning one.

  • for halogen headlight: Click here
  • for LED headlight: Click here
NEXT
  1. CLEAR DTCs

(a) Clear the DTCs.

Click here

Body Electrical > HL AutoLeveling > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Turn the ignition switch to ON.

(b) Operate the light control switch to turn on the low beam headlights.

(c) Check the DTCs.

Click here

Body Electrical > HL AutoLeveling > Trouble Codes

OK:

DTC B2439 is not output.

OK

END (LEFT HEADLIGHT UNIT ASSEMBLY WAS DEFECTIVE)

NG

REPLACE LEFT HEADLIGHT ECU SUBASSEMBLY

  1. REPLACE RIGHT HEADLIGHT UNIT ASSEMBLY

(a) Replace the right headlight unit assembly with a new or normally functioning one.

  • for halogen headlight: Click here
  • for LED headlight: Click here
NEXT
  1. CLEAR DTCs

(a) Clear the DTCs.

Click here

Body Electrical > HL AutoLeveling > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Turn the ignition switch to ON.

(b) Operate the light control switch to turn on the low beam headlights.

(c) Check the DTCs.

Click here

Body Electrical > HL AutoLeveling > Trouble Codes

OK:

DTC B243A is not output.

OK

END (RIGHT HEADLIGHT UNIT ASSEMBLY WAS DEFECTIVE)

NG

REPLACE RIGHT HEADLIGHT ECU SUBASSEMBLY