Exterior Lighting

Hazard Warning Switch Circuit

~2min read

DESCRIPTION

The combination meter assembly receives the hazard switch assembly ON signal and controls the operation of the hazard lights.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

When replacing the instrument cluster assembly, always use a new part. If an instrument cluster assembly that was installed in another vehicle is used, the stored information will not match the information transmitted by the vehicle, and a DTC may be stored.

PROCEDURE

  1. CHECK VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menus: Body Electrical / Combination Meter / Data List.

(e) Read the Data List by following the instructions on the Techstream.

Body Electrical > Combination Meter > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

Hazard Flasher Switch

Hazard warning switch signal

ON or OFF

ON: Hazard warning switch in ON position

OFF: Hazard warning switch in OFF position

-

Body Electrical > Combination Meter > Data List

Hazard Flasher Switch

OK:

The normal conditions listed above are displayed.

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG
  1. CHECK HAZARD SIGNAL SWITCH ASSEMBLY

(a) Remove the hazard signal switch assembly.

Click here

(b) Check the hazard switch assembly.

Click here

OK:

The hazard signal switch assembly is normal.

NG

REPLACE HAZARD SIGNAL SWITCH ASSEMBLY

OK
  1. CHECK WIRE HARNESS AND CONNECTOR (HAZARD SIGNAL SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY OR BODY GROUND)

(a) Disconnect the F5 combination meter assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F62-4 (TB) - F5-3 (HAZ)

Always

Below 1 Ω

F62-4 (TB) or F5-3 (HAZ) - Body ground

Always

10 kΩ minimum

F62-1 (E) - Body ground

Always

Below 1 Ω

OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR