Exterior Lighting

Precautions

~2min read

PRECAUTION

IGNITION SWITCH TERMS

(a) The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.

Term

Ignition Switch (Position)

Engine Switch (Condition)

Ignition Switch in OFF position

LOCK

OFF (Locked)

Ignition Switch in ACC position

ACC

ON (ACC)

Ignition Switch in ON position

ON

ON (IG)

Starting the engine

START

ON (Starting)

PRECAUTIONS WHEN REPLACING HEADLIGHT BULB

(a) If the surface of a headlight bulb is contaminated, even with a thin film of oil, its service life will be reduced because it burns at a much higher temperature. When replacing a bulb, hold the base of the headlight and do not touch the glass part of the headlight with your hands.

(b) The internal pressure of a headlight bulb is high. Any shock, drop or damage to the bulb may cause it to burst or explode.

(c) Always keep a new bulb on hand for immediate replacement. When replacing the bulb, dust and moisture may settle on the lens if the headlight is left open for a long time.

(d) Always replace a bulb with one of the same rated wattage.

(e) If only the bulbs on one side are replaced, differences in brightness and light color may appear between the left and right sides.

(f) Reinstall the socket correctly after replacing the bulb. If it is not installed properly, the lens may fog up or water may enter through the gaps around the socket.

CAUTION / NOTICE FOR REPLACING INSTRUMENT CLUSTER ASSEMBLY

(a) When replacing the instrument cluster assembly, replace it with a new part. If an instrument cluster assembly installed in another vehicle is used, the recorded information will not match the information transmitted by the vehicle, and a DTC may be stored.