Exterior Lighting

Operation Check

~4min read

OPERATION CHECK

AUTO LIGHT CONTROL SYSTEM OPERATION CHECK

(a) Turn the ignition switch to ON.

(b) Set the light control switch to the AUTO position.

(c) Cover the automatic light control sensor.

(d) Check that the tail lights and headlights turn on.

(e) Uncover the automatic light control sensor.

(f) Check that the low beam headlights and tail lights turn off.

AUTO LIGHT OFF SYSTEM OPERATION CHECK (without Toyota passenger detection safety)

(a) Close all doors.

(b) Turn the ignition switch to ON.

(c) Turn on the headlights, front fog lights*1, tail lights, parking lights and license plate lights.

  • *1: with fog light

(d) Turn the ignition switch to OFF.

(e) Open the driver's door.

(f) Check that all lights turn off immediately.

AUTO LIGHT OFF SYSTEM OPERATION CHECK (with Toyota passenger detection safety)

(a) When the tail lights are on (low beam headlights not on)

(1) Close all doors.

(2) Turn the ignition switch ON.

(3) Turn on the tail lights.

(4) Turn the ignition switch to OFF.

(5) Open the driver's door.

(6) Check that all lights turn off immediately.

(b) When the low beam headlights are on

(1) Close all doors.

(2) Turn the ignition switch ON.

(3) Turn on the low beam headlights.

(4) Turn the ignition switch to OFF.

(5) Open any door.

(6) Close the door.

(7) Check that all lights turn off after 30 seconds (delay function).

HINT:

Before the lights turn off, if the key lock button is pressed once all doors are locked, all lights turn off immediately.

DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK

(a) Set the light control switch to OFF, TAIL or AUTO (with the low beam headlights not on via the automatic light control system). (without DRL OFF switch)

(b) Set the light control switch to TAIL or AUTO (with the low beam headlights not on via the automatic light control system). (with DRL OFF switch)

(c) Start the engine.

(d) Release the parking brake.

(e) Check that the daytime running lights come on.

OUTSIDE REAR VIEW MIRROR PUDDLE LIGHT CONTROL OPERATION CHECK (with outside rear view mirror puddle light control)

(a) The operation and conditions of use of this control are described below.

Operation

Condition

Fades in and stays on

When one of the following conditions is met, the light fades in and stays on:

  • A key is within the operating area.
  • A door is unlocked with the ignition switch OFF and all doors closed.

Fades in and stays on

When one of the following conditions is met, the light fades in and stays on:

A door is unlocked with the ignition switch OFF and all doors closed.

Comes on for 15 seconds then fades out

When one of the following conditions is met, the headlights come on for 15 seconds, then fade out:

  • A function related to the operating area is used.*1
  • A door is unlocked with the ignition switch OFF and all doors closed.

Fades out immediately

When one of the following conditions is met, the light fades out immediately:

  • The ignition switch is changed from OFF to ON.
  • All doors lock when all doors are closed and one of the doors is unlocked.

HINT:

*1: When the headlights are on, if the key leaves the operating areas around the doors, the headlights fade out after approximately 3 seconds.

FOLLOW ME HOME OPERATION CHECK (without Toyota passenger detection safety)

(a) Turn the ignition switch OFF.

(b) Set the light control switch to the AUTO position.

(c) Pull the light control switch to flash the headlights once.

(d) Check that the low beam headlights come on for approximately 30 seconds.