Exterior Lighting

High Beam Indicator Circuit

~3min read

DESCRIPTION

The main body ECU (multiplex network body ECU) controls the high beams.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • Check the fuse for the circuits related to this system before performing the following procedure.
  • Check that the low beams operate normally. If the low beams do not operate normally, refer to the symptoms table.

    Click here

  • Before replacing the main body ECU (multiplex network body ECU), refer to the registration section.*1

    Click here

    • *1: with Smart Key System

PROCEDURE

  1. PERFORM ACTIVE TEST USING TECHSTREAM (HEAD LIGHT HI)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menu items: Body Electrical / Main Body / Active Test.

(e) Make sure the high beams come on.

Body Electrical > Main Body > Active Test

Tester display

Item

Control Range

Diagnostic Note

Headlight High

High Beam Headlights

ON or OFF

-

Body Electrical > Main Body > Active Test

Headlight High

OK:

The high beams come on.

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG
  1. CHECK H-LP SHADE RELAY

(a) Remove the H-LP SHADE relay from engine room relay block No. 1.

(b) Inspect the H-LP SHADE relay.

Click here

NG

REPLACE H-LP SHADE RELAY

OK
  1. CHECK HARNESS AND CONNECTOR (H-LP SHADE RELAY - BATTERY)

(a) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

Relay terminal 2 - Body ground

Always

11 à 14 V

Relay terminal 5 - Body ground

Always

11 à 14 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK HARNESS AND CONNECTOR (H-LP SHADE RELAY - LH HEADLIGHT ASSEMBLY AND RH HEADLIGHT ASSEMBLY AND BODY GROUND)

(a) Disconnect the A11 connector from the LH headlight assembly.

(b) Disconnect the A29 connector from the RH headlight assembly.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

Relay terminal 3 - A11-3 (SOL)

Always

Below 1 Ω

Relay terminal 3 - A29-3 (SOL)

Always

Below 1 Ω

A11-6 (E) - Body ground

Always

Below 1 Ω

A29-6 (E) - Body ground

Always

Below 1 Ω

Relay terminal 3 - Body ground

Always

10 kΩ minimum

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK HARNESS AND CONNECTOR (H-LP SHADE RELAY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))

(a) Disconnect the F15 connector from the main body ECU (multiplex network body ECU).

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

Relay terminal 1 - F15-1 (DIM)

Always

Below 1 Ω

Relay terminal 1 - Body ground

Always

10 kΩ minimum

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR