Exterior Lighting

Position light / daytime running light circuit

~3min read

DESCRIPTION

Tail light function:
  • When the main body ECU (multiplex network body ECU) receives the light control switch position signal, it sends a light request signal to the LH headlight ECU subassembly and turns on the tail lights.
Daytime running light function:
  • When the daytime running light operating conditions are met, the main body ECU (multiplex network body ECU) sends a light request signal to the LH headlight ECU subassembly and turns on the daytime running lights.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

If the left headlight ECU subassembly has been replaced, it is necessary to synchronize the vehicle information and reset the left headlight ECU subassembly.

Click here

PROCEDURE

  1. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Select the following menus: Body Electrical / HL AutoLeveling / Active Test.

(d) Perform the Active Test by following the Techstream instructions.

Body Electrical > HL AutoLeveling > Active Test

Tester display

Item

Control Range

Diagnostic Note

Clearance Light

Clearance lights

ON or OFF

-

Daytime Running Light

Daytime Running Lights

ON or OFF

-

Body Electrical > HL AutoLeveling > Active Test

Clearance Light

Body Electrical > HL AutoLeveling > Active Test

Daytime Running Light

OK:

The tail lights and daytime running lights come on.

Result:

Result

Proceed to

OK

A

NG (for left side)

B

NG (for right side)

C

A

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

C

GO TO STEP 3

B
  1. REPLACE LEFT HEADLIGHT UNIT ASSEMBLY

(a) Replace the left headlight unit assembly with a new or normally functioning one.

  • for halogen headlight: Click here
  • for LED headlight: Click here

(b) Check that the LH tail light and LH daytime running light operate normally.

OK:

The LH tail light and LH daytime running light operate normally.

OK

END (LEFT HEADLIGHT UNIT ASSEMBLY WAS DEFECTIVE)

NG

REPLACE LEFT HEADLIGHT ECU SUBASSEMBLY

  1. REPLACE RIGHT HEADLIGHT UNIT ASSEMBLY

(a) Replace the right headlight unit assembly with a new or normally functioning one.

  • for halogen headlight: Click here
  • for LED headlight: Click here

(b) Check that the RH tail light and RH daytime running light operate normally.

OK:

The RH tail light and RH daytime running light operate normally.

OK

END (RIGHT HEADLIGHT UNIT ASSEMBLY WAS DEFECTIVE)

NG

REPLACE RIGHT HEADLIGHT ECU SUBASSEMBLY