Exterior Lighting

How to Use Troubleshooting

~2min read

PRECAUTION / NOTICE / HINT

HINT:

  • Apply the following procedure to troubleshoot the lighting system.
  • *: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CONFIRMATION

NEXT
  1. CHECK BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 à 14 V

If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.

NEXT
  1. CHECK CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check whether the CAN communication system is operating normally.

Click here

Result:

Result

Proceed to

CAN communication system DTCs are not output

A

CAN communication system DTCs are output

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTCs*

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menus: Body Electrical / Main Body / Trouble Codes.

(e) Check the DTCs.

Click here

Body Electrical > Main Body > Trouble Codes Body Electrical > HL AutoLeveling > Trouble Codes

Result:

Result

Proceed to

No DTCs are output

A

DTCs are output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART (LIGHTING SYSTEM)

A
  1. SYMPTOM TROUBLESHOOTING TABLE

(a) Refer to the Symptom Troubleshooting Table.

Click here

Result:

Result

Proceed to

The malfunction is not listed in the Problem Symptoms Table

A

The malfunction is listed in the Problem Symptoms Table

B

B

REFER TO SYMPTOM TROUBLESHOOTING TABLE

A
  1. GENERAL ANALYSIS AND TROUBLESHOOTING*

(a) Data List/Active Test

Click here

(b) ECU Terminals

Click here

(c) Inspection

(d) Vehicle Inspection

NEXT
  1. ADJUST, REPAIR OR REPLACE

NEXT
  1. CONFIRMATION TEST

NEXT

END