Exterior Lighting

Data List / Active Test

~9min read

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not determine whether a part is faulty based only on these reference values.

HINT:

The Techstream Data List allows you to read the values or status of switches, sensors, actuators and other components without removing any parts. This non-intrusive check can be very useful, since intermittent conditions or signals can be identified before parts or wiring are moved. Reading the Data List during troubleshooting saves time in diagnosis.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menu items: Body Electrical / Main Body, Combination Meter or HL AutoLeveling (for LED headlight) / Data List.

(e) Read the Data List by following the instructions on the Techstream.

Body Electrical > Main Body > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

Dimmer SW

High beam/low beam switch HIGH position signal

ON or OFF

ON: High beam/low beam switch in HIGH or HIGH FLASH position

OFF: High beam/low beam switch in LOW position

-

Passing Light SW

High beam/low beam switch HIGH FLASH (Pass) position signal

ON or OFF

ON: High beam/low beam switch in HIGH FLASH position

OFF: High beam/low beam switch in a position other than HIGH FLASH

-

Front Fog Light SW

Front fog light switch position signal

ON or OFF

ON: Front fog light switch in the front position

OFF: Fog light switch in OFF position

*1

Auto Light SW

Light control switch AUTO position signal

ON or OFF

ON: Light control switch in AUTO position

OFF: Light control switch is not in AUTO position

-

Head Light SW (Head)

Light control switch HEAD position signal

ON or OFF

ON: Light control switch in HEAD position

OFF: Light control switch is not in HEAD position

-

Head Light SW (Tail)

Light control switch TAIL position signal

ON or OFF

ON: Light control switch in TAIL or HEAD position

OFF: Light control switch is not in TAIL (tail lights) or HEAD (headlights) position

-

Light Sensor Illuminance

Light control sensor illuminance

0 to 8,191 lx

The value is output according to the ambient brightness level

-

Headlight Lighting Function

ECU controlling the lighting system

Main body or ignition system ECU

Main body: Lighting system controlled by the main body ECU (multiplex network body ECU)

Lighting system ECU: Lighting system controlled by the headlight ECU subassembly

-

Sensitivity

Auto Light Control Sensitivity

Light2, Light1, Normal, Dark1 or Dark2

Customised setting displayed

-

DRL Function

Daytime running light function setting is ON/OFF

ON or OFF

Customised setting displayed

*2

Disp Ex ON Sen

Ambient brightness level required for dimming the display illumination (instrument cluster, navigation system screen, etc.)

Light2, Light1, Normal, Dark1 or Dark2

Customised setting displayed

-

Disp Ex OFF Sen

Ambient brightness level required to cancel dimming of the display illumination (instrument cluster, navigation system screen, etc.)

Light2, Light1, Normal, Dark1 or Dark2

Customised setting displayed

-

Light Auto OFF Delay

Auto light off delay time

Off, 30 s, 60 s or 90 s

Customised setting displayed

*2

Follow Me Home Lighting Time

Follow me home lighting duration

30 s, 60 s, 90 s or 120 s

Customised setting displayed

*3

The Number of DTC

Number of DTCs

0 à 255

Number of stored DTCs displayed

-

  • *1: with fog light
  • *2: with Toyota Safety Sense P system
  • *3: without Toyota Safety Sense P system
Body Electrical > Combination Meter > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

Turn Signal Switch (Right)

Turn signal switch (right) signal

ON or OFF

ON: Right turn signal switch in ON position

OFF: Right turn signal switch in OFF position

-

Turn Signal Switch (Left)

Turn signal switch (left) signal

ON or OFF

ON: Left turn signal switch in ON position

OFF: Left turn signal switch in OFF position

-

Hazard Flasher Switch

Hazard warning switch signal

ON or OFF

ON: Hazard warning switch in ON position

OFF: Hazard warning switch in OFF position

-

Turn Switch Signal (Full Turn)

Turn signal switch signal (full turn)

ON or OFF

ON: Turn signal switch (left or right) in ON position

OFF: Turn signal switch (left and right) in OFF position

-

Lane Change Flashing Times Setting

Lane change turn signal flashing count status

OFF, 3, 4, 5, 6, 7

Customised setting displayed

-

Body Electrical > HL AutoLeveling > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

Headlight Low Beam State

Low beam headlight status

ON or OFF

ON: Low beam headlights on

OFF: Low beam headlights off

-

Headlight High Beam State

High beam headlight status

ON or OFF

ON: High beam headlights on

OFF: High beam headlights off

-

DRL Operating State

Daytime running light status

ON or OFF

ON: Daytime running lights on

OFF: Daytime running lights off

-

Clearance Light State

Clearance light status

ON or OFF

ON: Clearance lights on

OFF: Clearance lights off

-

+B

Left headlight ECU sub-assembly ignition power supply voltage value

0 à 19,75 V

11,00 à 14,00 V

-

Height Sens Pw Supply Val

Rear left height control sensor subassembly power supply voltage value

0 à 5,00 V

4,61 à 5,00 V

-

Rr Height Sens Signal Val

Rear left height control sensor subassembly signal value

0 à 5,00 V

0,50 à 4,50 V

-

Front Right Wheel Speed Value

Front right wheel speed

0,00 à 260 km/h

Vehicle stopped: 0 km/h

-

Front Left Wheel Speed Value

Front left wheel speed

0,00 à 260 km/h

Vehicle stopped: 0 km/h

-

Vehicle Speed

Vehicle speed

0,00 à 260 km/h

Vehicle stopped: 0 km/h

-

Rear Height Adjust Value

Rear height adjustment offset value

0 à 1 023

The normal rear height adjustment value is displayed in this state (if a malfunction is detected, no value is displayed)

-

Rear Height Adjust Valid Flag

Rear height adjustment range

Valid or Invalid

Valid: Rear height control sensor subassembly value within the normal range

Invalid: Rear height control sensor subassembly value outside the normal range

-

Init Writing Count

Number of times initialization has been performed

0 à 255

Number of times initialization has been performed

-

Sensor Initialization Hist

Sensor initialization history

Non-compliant, 10%, 25%, 50%, 75%, 100% or Compliant

  • Not completed: Left headlight ECU subassembly not initialized after replacement.
  • 10%: Initialization completed with fuel tank filled to 10%
  • 25%: Initialization completed with fuel tank filled to 25%
  • 50%: Initialization completed with fuel tank filled to 50%
  • 75%: Initialization completed with fuel tank filled to 75%
  • 100%: Initialization completed with fuel tank filled to 100%
  • Compliant: ECU not replaced and ECU not initialized in the workshop.

-

+B Voltage Value

Left headlight ECU subassembly power supply voltage value

0 à 19,75 V

11,00 à 14,00 V

-

Leveling Motor Target Position

Headlight Leveling Motor Target Position

0 à 102,3 %

10 à 90 %

-

Number Of Trouble Codes

Number of DTCs

0 à 255

Number of stored DTCs displayed

-

ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing parts. This non-intrusive functional check can be very useful, because intermittent operation can be identified before parts or wiring are moved. Performing Active Tests at the start of troubleshooting saves time during diagnosis. Data List information can be displayed during Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menus: Body Electrical / Main Body or HL AutoLeveling (for LED headlight) / Active Test.

(e) Perform the Active Test by following the Techstream instructions.

Body Electrical > Main Body > Active Test

Tester display

Item

Control Range

Diagnostic Note

Daytime Running Light

Daytime Running Lights

ON or OFF

-

Side Mirror Foot Light

Side Mirror Foot Lights

ON or OFF

*1

Taillight Relay

Taillight Relay

ON or OFF

-

Headlight Relay

Low beam headlights

ON or OFF

-

Headlight High

High Beam Headlights

ON or OFF

-

Front Fog Light Relay

Front Fog Lights

ON or OFF

Lighting control switch in TAIL position*2

  • *1: with side mirror foot lights
  • *2: With fog light
Body Electrical > HL AutoLeveling > Active Test

Tester display

Item

Control Range

Diagnostic Note

Clearance Light

Clearance lights

ON or OFF

-

Headlight Low Beam

Low beam headlights

ON or OFF

-

Headlight High Beam

High Beam Headlights

ON or OFF

-

Daytime Running Light

Daytime Running Lights

ON or OFF

-

Headlight Indicator

"Headlight System Malfunction Visit Your Dealer" displayed

ON or OFF

-