Reservoir

Remove or disconnect

Reservoir Removal. A. Screwdriver

2. RESERVOIR

5. BRAKE MASTER CYLINDER BODY

PROCEDURE.

1. Disconnect wire terminals from reservoir cover

1..

2. Drain the reservoir

2..

3. Using a screwdriver, pry out reservoir retainers 4.

4. Tilt reservoir 2 and lift it off the brake master cylinder.

5. Remove reservoir seal bushings 3 from brake master cylinder body 5.

Install or connect

Installation of Reservoir Retainers

2. RESERVOIR

4. RESERVOIR RETAINER

PROCEDURE.

1. Lubricate reservoir seal bushings 3 with fresh brake fluid and install in

brake master cylinder body 5.

2. Install new retainers 4 on reservoir.

2..

3. Install reservoir 2 onto brake master cylinder body 5.

Warning.

When installed correctly, retainers 4 snap into place.

4. Bleed air from the hydraulic system.

5. Connect wires to reservoir cover terminals.