Brake Pads and Linings

Remove or disconnect

Removal of pins. A. Pin punch.

B. HAMMER.

1. RETURN SPRING.

4. CALIPER HOUSING, INNER PART.

10. PIN.

24. CALIPER HOUSING, OUTER PART

Before starting work, raise and secure the vehicle properly.

PROCEDURE.

1. Front wheels.

Warning.

To replace pads or service the brake disc, remove

brake caliper is not required.

2. Pins 10 from the caliper holes using a pin punch and hammer. Remove the pins.

by tapping with a hammer from the inside of the caliper.

3. Retaining springs.

Warning.

Springs are compressed and may fly out. Be

careful when removing the pins.

4. Pads from the caliper.

4a. Remove the outer pad.

4b. Press in the piston and remove the inner pad.

Install or connect

Installation of pins and retaining springs

1. RETURN SPRING.

10. PINS

PROCEDURE.

1. Install brake pads into the caliper. The pad wear sensor must be located on top of the inner pad.

Warning.

The replacement parts kit includes three types of pads: left inner, right

inner and two identical outer pads. When installing, the wear sensors

must be located on top of the inner pads. Installation errors

pads will reduce brake system performance and reduce

vehicle safety.

2. Upper pin. Install from the outside of the caliper.

3. Retaining springs. Insert the long ends of the springs under the pins.

4. Lower pin. Install from the outside of the caliper. Make sure the long ends of the springs are under the pins.

5. Front wheels..

6. Lower the vehicle.