Fiat Bravo Quiz
Body

Removing and installing door trim panel

In this manual: Body
Dear Reader — 1Engine — 35Engine lubrication — 3Engine cooling — 10Ignition/spark plugs — 14Fuel system — 10Petrol fuel injection — 13Diesel injection system — 13Exhaust system — 7Clutch — 7Transmission / Gearshift / Automatic Transmission — 5Front Axle — 11Rear axle — 4Steering — 9Wheel alignment — 1Brake system — 22Wheels and tyres — 10Body — 34Heating — 6Electrical system — 39Lighting system — 14Instruments — 7Windscreen wiper system — 8Vehicle care / tools — 6Jump Starting / Towing the Vehicle — 3Jacking up the vehicle — 1Fiat Bravo / Brava Maintenance Schedule — 1Maintenance — 38Wiring diagrams — 5
~2min read
Removal

  • Lower the door window fully.

Türverkleidung aus-und einbauen

  • Remove the door handle by unscrewing the 2 screws and take it off.

Türverkleidung aus-und einbauen

  • Lift off the window switch plate with a screwdriver. Place paper padding or a cloth underneath to avoid damaging the door trim panel.

  • Disconnect the multi-plug and remove the switch.

Türverkleidung aus-und einbauen

  • If fitted, remove the window regulator handle. To do so, insert a screwdriver between escutcheon - 4 - and handle - 5 - next to the handle spindle and press out retaining clip - 6 -, see illustration. Pull the window regulator handle off the spindle. Reinstall the retaining clip into the handle immediately after removal.

Türverkleidung aus-und einbauen

  • Unscrew and remove the door trim panel. For the mounting screws of the rear door trim panel, see end of chapter.

Türverkleidung aus-und einbauen

  • Pry out the fastening clips with a suitable lever - 1 -.

    In this case, insert a cloth to prevent scratching the paint. Turn the side door stops, see arrow right, and remove them.

Türverkleidung aus-und einbauen

  • Carefully pull the door film off the door. Take care not to tear the film.

Caution: The door film can be pressed back on later, provided the adhesive does not dry out or become contaminated. Do not touch the exposed adhesive surfaces, as this would impair adhesion for later reinstallation. Installation

  • Position the door film and press it onto the adhesive points.

    Carefully repair damaged protective film and damaged adhesive points with double-sided adhesive tape. For larger tears or damage, replace the door film.

    Caution: pay particular attention to the door film fitting tightly.

    Otherwise, wind noise may occur in the vehicle or water may enter the interior.

  • Check the plastic clips for proper condition, press them in and check for a secure fit. Replace any damaged clip.

  • Insert the door trim panel into the door cutout and tap the retaining clips firmly into place with the heel of your hand.

  • Secure the door trim panel with screws.

  • If fitted, push the window crank with the steel spring inserted onto the splines of the shaft until it engages.

    With the window closed, the window crank lever points forward.

  • Plug the multi-pin connector onto the power window switches. Fit the switch plate and snap it into place.

  • Secure the door handle with 2 screws.

Mounting screws of rear door trim panel:
Befestigungsschrauben der hinteren türverkleidung

Test yourself

A quick Fiat Bravo quiz: every answer comes with an explanation and a link to the manual page.