Body Electrical System
Specification
In this manual: Body Electrical System
4steps
~24min
2/5difficulty
Done 0 of 4
Contents:
Specification
Specification
| Item | Specified value (V) | |
| Rated voltage (V) | DC +5 | |
| Illuminations (Lux) | 100 | 0.59 - 0.93 |
| 200 | 1.00 - 1.60 | |
Description and Operation
Description
- This system uses an illumination sensor to automatically turn ON the tail lamp and headlamp based on the ambient light change in surrounding environment's.
- It activates when the vehicle enters/exits tunnel, or when the illumination condition in surrounding environment changes due to rain, snow, or fog.
Auto Light Sensor Removal and Installation
Removal
- Disconnect the negative ( - ) battery terminal.
- Remove the front center speaker grille (A) by using the remover.


Clip position :

- Disconnect the auto light sensor connector (A).

- Remove the auto light sensor (A) by pressing the hooks in the direction of the arrows.


Installation
- Install in reverse order of removal.
Was this page helpful?