Body Electrical System

Ignition Switch Assembly

12steps
~72min
3/5difficulty
0102030405012.79N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Contents:

Ignition Switch On Vehicle Inspection

On Vehicle Inspection

Diagnosis with KDS

  1. The body electrical system can be more quickly diagnosed for problems with the KDS (Refer to "DTC guide").
    1. Self diagnosis : Inspect the Diagnostic Trouble Code (DTC) with the KDS. (Refer to DTC guide when fault code is found.)
    Information
    Refer to the KDS screen for operating conditions and details.

Ignition Switch Removal and Installation

Removal

Ignition Lock Switch Assembly
  1. Remove the crash pad center garnish. (Refer to Body - "Crash Pad Garnish")
  2. Remove the steering column shroud panel. (Refer to Body - "Steering Column Shroud Panel")
  3. Disconnect the key warning switch connector (A) and ignition switch connector (B).
    Body Electrical System — Ignition Switch Assembly / Ignition Switch / Removal and Installation / Removal illustration
  4. Remove the ignition switch (A) by removing the clamp (B) after removing the bolts.

    Tightening torque : 6.9 - 12,7 N·m

    Body Electrical System — Ignition Switch Assembly / Ignition Switch / Removal and Installation / Removal illustration
  5. Disconnect the negative battery terminal.
  6. Remove the steering column upper & lower shroud panel. (Refer to Body - "Steering Column Shroud Panel")
  7. Insert key and turn it to ACC position.
  8. Disconnect the connector (A).
    Body Electrical System — Ignition Switch Assembly / Ignition Switch / Removal and Installation / Removal illustration
  9. Remove the key lock cylinder (A) after pushing the lock pin (B).
    Body Electrical System — Ignition Switch Assembly / Ignition Switch / Removal and Installation / Removal illustration
Key Lock Cylinder

Installation

  1. Install in reverse order of removal.
    Note
    • The existing shear bolts must be replaced with a new one. (Do not reuse it.)
    • Tighten the shear bolts until its head is cut off.
      Body Electrical System — Ignition Switch Assembly / Ignition Switch / Removal and Installation / Installation illustration

Ignition Switch Inspection

Inspection

  1. Disconnect the negative ( - ) battery terminal.
  2. Disconnect the key warning switch connector (A) and ignition switch connector (B).
    Body Electrical System — Ignition Switch Assembly / Ignition Switch / Inspection illustration
  3. Check for continuity between the terminals.
    Body Electrical System — Ignition Switch Assembly / Ignition Switch / Inspection illustration