Body Electrical System
Horn
In this manual: Body Electrical System
5steps
~30min
2/5difficulty
Done 0 of 5
Contents:
Specification
Specification
| Item | Specification | Possible Cause |
| Operating voltage (V) | 9 - 16 | - |
| Current consumption (A) | MAX 5.0 | At 12 V |
| Sound level (dB) | 108 - 114 | At 13 V, Measuring distance : 2 m (6.56 ft.) |
| Insulated resistance (MΩ) | MIN 1 | By 500 V megameter |
Removal and Installation
Removal
- Remove the front bumper assembly. (Refer to Body - "Front Bumper Assembly")
- Disconnect the horn connector (A).

- Remove the horn (A) after removing the bolt.
Tightening torque : 11.8 - 12,7 N·m

Installation
- Install in reverse order of removal.
Inspection
Inspection
- Apply battery voltage to terminal 1 (ground) and terminal 2 (battery+) and verify that it operates.

- Check fuse and relay.

- The semi-conductor type relay inserted in the PCB is impossible to replace. If the relay needs to be replaced, replace the metal core box and conduct a test on it. (Refer to Fuses And Relays - "Engine Room Junction Block")
Was this page helpful?