Body Electrical System
Electro Chromic Inside Rear View Mirror
In this manual: Body Electrical System
14steps
~84min
3/5difficulty
Done 0 of 14
Contents:
Description and Operation
Description
Electro Chromic Inside Rear View Mirror- The ECM (Electro Chromatic inside rear view Mirror) automatically dims to protect the driver’s eyes when it senses light reflecting from the car behind.
- The sensor in the mirror detects the brightness and if the headlight from the car behind is reflected on the mirror, the chemical layer inside the mirror reacts to glare and adjusts the reflectivity from 10 to 70%.
- When switching to the reverse gear, the mirror becomes bright regardless of the surrounding.
- The ECM (A) receives voltage, ground and reverse gear signals measure the glaring intensity.

Terminal Function
Connector and Terminal Function

| Connector A | Terminal | Function | Terminal | Function |
![]() |
1 | - | 6 | - |
| 2 | - | 7 | - | |
| 3 | - | 8 | Ground | |
| 4 | - | 9 | Back-up lamp signal | |
| 5 | - | 10 | IG 1 |
On Vehicle Inspection
On Vehicle Inspection
Inspect by the procedure below to see if the function of the ECM is normal.- After IG ON, using cloth cover the forward sensor.
- It illuminates the rear sensor.
- The ECM dims as soon as the rearward-facing sensor detects a certain level of brightness.
If this test is performed in daytime, the ECM may be darkened as soon as the forward facing sensor is covered.
- In the reverse gear, the ECM should not dim.
- ECM should not darken when light is illuminated on the front and rear sensors, respectively.
Removal and Installation
Removal
- Disconnect the negative ( - ) battery terminal.
- Remove the multi sensor blanking cover (A).


Clip position :

- Remove the multi sensor cover (A) in the direction of the arrow.


Clip position :

- Disconnect the inside rear view mirror connector (A).

- Remove the inside rear view mirror (A) after removing the screw.

Installation
- Install in reverse order of removal.
Was this page helpful?
