Body Electrical System
Multifunction Switch
In this manual: Body Electrical System
3steps
~18min
2/5difficulty
Done 0 of 3
Contents:
Specification
Specification
| Item | Rated Voltage (V) |
| Front fog lamp switch | 5 |
| Front lighting switch | |
| Dimmer & Passing | |
| Turn signal lamp | |
| Wiper | |
| Washer | 12 |
Terminal Function
Connector and Terminal Function

| Connector A | |
| Terminal | Function |
| 1 | Front wiper switch |
| 2 | Front wiper switch back-up signal (Low) |
| 3 | - |
| 4 | Rear washer motor switch |
| 5 | Turn signal switch (RH) |
| 6 | Front washer motor switch |
| 7 | Front wiper INT volume signal |
| 8 | IG2 |
| 9 | Ground (Vehicle) |
| 10 | Fog lamp switch |
| 11 | Ground (IBU) |
| 12 | Turn signal switch (LH) |
| 13 | Dimmer/Passing switch |
| 14 | Front lighting switch |
| 15 | Headlamp low back up signal |
| 16 | Rear wiper switch |
Removal and Installation
Removal
- Remove the clock spring. (Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
- Disconnect the multifunction switch connector (A).

- Remove the multifunction switch assembly (A) after removing the screws.

Installation
- Install in reverse order of removal.
Inspection
Inspection
Component Inspection- Check for continuity between the terminals in each switch position as shown below.

Switch Switch position Switch terminal Resistance (Ω, ±3.5%) Front wiper switch MIST 1 - 9 330 OFF ∞ INT (AUTO) 800 Low 1,800 High 5,700 Wiper intermittent volume Volume 1 7 - 9 330 Volume 2 590 Volume 3 1,310 Volume 4 2,610 Volume 5 7,310 Front fog lamp switch OFF 9 - 10 ∞ ON 910 Turn signal lamp switch (RH) OFF 9 - 5 ∞ RH 2,910 Turn signal lamp switch (LH) OFF 9 - 12 ∞ LH 2,910 Dimmer & Passing switch OFF 9 - 13 ∞ Passing 910 Dimmer 2,910 Light switch OFF 9 - 14 680 AUTO ∞ Tail lamp 1,680 Low beam 5,580 Rear wiper switch Low 9 - 16 910 High 2,910
Was this page helpful?