Suspension and Steering

Steering Gear Boots

~1min read

Replacement

PROCEDURE

1. Disconnect the tie rod.

2. Loosen the tie rod locknut.

3. Mark the position of the boot edge on the rack, spread the clamp rings, and remove the boot.

4. Thoroughly clean the rack and gear housing of dirt and grease.

5. Apply grease from the old boot to the inner joint (if the boot shows no signs of damage).

6. Install the new boot, align the edge with the mark on the rack, and secure it with a new clamp ring.

7. Tighten the locknut.

8. Connect the tie rod.

Test yourself

A quick Nissan Sunny quiz: every answer comes with an explanation and a link to the manual page.