Fuel Lid Opener Switch
Components
COMPONENTS
ILLUSTRATION
*1 |
COWL SIDE TRIM SUB-ASSEMBLY LH |
*2 |
FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
*3 |
FRONT DOOR SCUFF PLATE LH |
*4 |
FUEL LID OPENER SWITCH |
*5 |
HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
*6 |
INSTRUMENT SIDE PANEL LH |
*7 |
NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
*8 |
NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL LID OPENER SWITCH
(a) Check the switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the fuel lid opener switch. |
|
(b) Check the switch illumination.
(1) Apply auxiliary battery voltage to the switch connector and check that the fuel lid opener switch illuminates.
OK:
Auxiliary Battery Condition | Specified Condition |
|---|---|
Auxiliary battery positive (+) → Terminal 6 Auxiliary battery negative (-) → Terminal 1 |
Illumination illuminates |
If the result is not as specified, replace the fuel lid opener switch.
Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL LID OPENER SWITCH
(a) Engage the 2 claws to install the fuel lid opener switch as shown in the illustration.
![]() |
Install in this Direction |
2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here ![]()
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here ![]()
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here ![]()
5. INSTALL INSTRUMENT SIDE PANEL LH
Click here ![]()
6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here ![]()
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here ![]()
8. INSTALL FRONT DOOR SCUFF PLATE LH
Click here ![]()
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here ![]()
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here ![]()
3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here ![]()
4. REMOVE INSTRUMENT SIDE PANEL LH
Click here ![]()
5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here ![]()
6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here ![]()
7. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here ![]()
8. REMOVE FUEL LID OPENER SWITCH
(a) Disengage the 2 claws and remove the fuel lid opener switch as shown in the illustration.
![]() |
Remove in this Direction |


