Outer Rear View Mirror Glass
Components
COMPONENTS
ILLUSTRATION
*1 |
OUTER MIRROR |
- |
- |
Inspection
INSPECTION
PROCEDURE
1. INSPECT OUTER MIRROR RH
(a) Check the outer mirror heater operation. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the outer mirror RH. |
|
(b) Check the operation of the outer rear view mirror indicator.
NOTICE:
Do not apply a voltage of more than 4.5 V.
(1) Connect 3 new 1.5 V dry-cell batteries in series.
(2) Apply 4.5 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on. OK:
If the result is not as specified, replace the outer mirror RH. |
|
2. INSPECT OUTER MIRROR LH
(a) Check the outer mirror heater operation. (1) Measure the resistance according the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the outer mirror LH. |
|
(b) Check the operation of the outer rear view mirror indicator.
NOTICE:
Do not apply a voltage of more than 4.5 V.
(1) Connect 3 new 1.5 V dry-cell batteries in series.
(2) Apply 4.5 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on. OK:
If the result is not as specified, replace the outer mirror LH. |
|
Installation
INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL OUTER MIRROR
(a) Connect each connector.
(b) Engage the 8 claws to install the outer mirror. NOTICE: Do not push the outer mirror with excessive force. Doing so may break the mirror surface. |
![]() |
Removal
REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE OUTER MIRROR
(a) Apply protective tape to the areas shown in the illustration.
![]() |
Protective Tape |
(b) Push the upper part of the mirror surface and tilt it.
NOTICE:
Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
(c) Using a moulding remover and screwdriver, disengage the 8 claws as shown in the illustration.
(d) Disconnect each connector to remove the outer mirror. |
![]() |






