Vehicle Exterior
Rear Wheel House Plate
In this manual: Vehicle Exterior
~1min read
Components
COMPONENTS
ILLUSTRATION
*1 |
FRONT ROCKER PANEL MOULDING END COVER |
*2 |
CLIP |
в—Џ |
Non-reusable part |
- |
- |
Installation
INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT ROCKER PANEL MOULDING END COVER
(a) Install the front rocker panel moulding end cover with the screw.
(b) Install a new clip.
Removal
REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT ROCKER PANEL MOULDING END COVER
(a) Remove the clip. |
![]() |
(b) Remove the screw and front rocker panel moulding end cover.
Was this page helpful?
