Vehicle Exterior

Vehicle Approaching Speaker Ecu

~2min read
0102030405012.59N·mlb·ft
Tightening torque found on this page

Components

COMPONENTS

ILLUSTRATION

*1

LOWER INSTRUMENT PANEL SUB-ASSEMBLY

*2

VEHICLE APPROACHING SPEAKER CONTROLLER

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

Installation

INSTALLATION

PROCEDURE

1. INSTALL VEHICLE APPROACHING SPEAKER CONTROLLER

(a) Connect the connector.

(b) Engage the guide.

(c) Install the vehicle approaching speaker controller with the nut.

Torque:

12,5 N·m {127 kgf·cm, 9 ft·lbf}

2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Click here

3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Click here

Removal

REMOVAL

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during vehicle approaching speaker controller removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

*: When performing learning using the Techstream.

Click here

Disconnect cable from negative battery terminal

Perform steering sensor zero point calibration

Lane departure alert system (w/ Steering Control)

Pre-collision system

Intelligent clearance sonar system*

Lighting system (for Gasoline Model with Cornering Light)

Memorize steering angle neutral point

Parking assist monitor system

Panoramic view monitor system

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

*: When performing learning using the Techstream.

Click here

Disconnect cable from negative auxiliary battery terminal

Perform steering sensor zero point calibration

Lane departure alert system (w/ Steering Control)

Pre-collision system

Intelligent clearance sonar system*

Lighting system (for HV Model with Cornering Light)

Memorize steering angle neutral point

Parking assist monitor system

Panoramic view monitor system

PROCEDURE

1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Click here

2. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Click here

3. REMOVE VEHICLE APPROACHING SPEAKER CONTROLLER

(a) Remove the nut.

(b) Disengage the guide.

(c) Disconnect the connector to remove the vehicle approaching speaker controller.