Vehicle Exterior
Relay
In this manual: Vehicle Exterior
~1min read
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT HORN RELAY
*a |
Component without harness connected (HORN Relay) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
3 - 5 |
Auxiliary battery voltage not applied between terminals 1 and 2 |
10 kО© or higher |
3 - 5 |
Auxiliary battery voltage applied between terminals 1 and 2 |
Below 1 О© |
If the result is not as specified, replace the HORN relay.
Was this page helpful?