Washer Nozzle
Adjustment
ADJUSTMENT
PROCEDURE
1. REMOVE WASHER NOZZLE SUB-ASSEMBLY
Click here ![]()
2. ADJUST WASHER NOZZLE SUB-ASSEMBLY
(a) Select a washer nozzle sub-assembly so the position the washer fluid hits the windshield will be within the standard area. Replace the washer nozzle sub-assembly with the selected one.
*a |
Washer Fluid Spray Angle |
*b |
Part Number |
*c |
Right Mark |
*d |
Left Mark |
3. INSTALL WASHER NOZZLE SUB-ASSEMBLY
Click here ![]()
Components
COMPONENTS
ILLUSTRATION
*1 |
WASHER NOZZLE SUB-ASSEMBLY |
- |
- |
● |
Non-reusable part |
- |
- |
Installation
INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL WASHER NOZZLE SUB-ASSEMBLY
(a) Connect a new washer nozzle sub-assembly to the washer hose.
(b) Engage the 2 claws as indicated by the arrows, in the order shown in the illustration to install the washer nozzle sub-assembly.
![]() |
Install in this Direction (1) |
![]() |
Install in this Direction (2) |
2. INSPECT WASHER NOZZLE SUB-ASSEMBLY
Click here ![]()
3. ADJUST WASHER NOZZLE SUB-ASSEMBLY
Click here ![]()
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WASHER NOZZLE SUB-ASSEMBLY
(a) Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Standard:
Center of washer fluid contacts the windshield in the areas shown in the illustration.
HINT:
If the result is not as specified, replace the washer nozzle sub-assembly.
Text in Illustration*a |
Passenger Side Lower Spray (+1°) |
*b |
Passenger Side Lower Spray (0°) |
*c |
Passenger Side Lower Spray (-1°) |
*d |
Driver Side Lower Spray (+1°) |
*e |
Driver Side Lower Spray (0°) |
*f |
Driver Side Lower Spray (-1°) |
*g |
Passenger Side Upper Spray (+1°) |
*h |
Passenger Side Upper Spray (0°) |
*i |
Passenger Side Upper Spray (-1°) |
*j |
Driver Side Upper Spray (+1°) |
*k |
Driver Side Upper Spray (0°) |
*l |
Driver Side Upper Spray (-1°) |
Removal
REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE WASHER NOZZLE SUB-ASSEMBLY
(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration to separate the washer nozzle sub-assembly.
*a |
Protective Tape |
![]() |
Remove in this Direction (1) |
![]() |
Remove in this Direction (2) |
NOTICE:
Be careful not to damage the windshield glass.
(b) Disconnect the washer hose to remove the washer nozzle sub-assembly. NOTICE: Washer nozzle sub-assemblies cannot be reused. |
![]() |




