Rear Light Assembly
Components
COMPONENTS
ILLUSTRATION
*1 |
LUGGAGE COMPARTMENT DOOR COVER |
- |
- |
ILLUSTRATION
*1 |
REAR LIGHT ASSEMBLY |
*2 |
REAR LIGHT CORD |
*3 |
REAR LIGHT GASKET |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
Disassembly
DISASSEMBLY
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR LIGHT GASKET
(a) Remove the rear light gasket. NOTICE:
|
![]() |
2. REMOVE REAR LIGHT CORD
(a) Disconnect the connector to remove the rear light cord with rear light gasket. |
![]() |
(b) Remove the rear light gasket from the rear light cord.
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR LIGHT ASSEMBLY LH (w/o Seaquential Turn Light)
(a) Apply auxiliary battery voltage to the rear light assembly LH and check that the lights illuminate. OK:
If the result is not as specified, replace the rear light assembly LH. |
|
2. INSPECT REAR LIGHT ASSEMBLY RH (w/o Seaquential Turn Light)
(a) Apply auxiliary battery voltage to the rear light assembly RH and check that the lights illuminate. OK:
If the result is not as specified, replace the rear light assembly RH. |
|
3. INSPECT REAR LIGHT ASSEMBLY LH (w/ Seaquential Turn Light)
(a) Apply auxiliary battery voltage to the rear light assembly LH and check that the lights illuminate. OK:
If the result is not as specified, replace the rear light assembly LH. |
|
4. INSPECT REAR LIGHT ASSEMBLY RH (w/ Seaquential Turn Light)
(a) Apply auxiliary battery voltage to the rear light assembly RH and check that the lights illuminate. OK:
If the result is not as specified, replace the rear light assembly RH. |
|
Installation
INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR LIGHT ASSEMBLY
(a) Engage the clip. |
![]() |
(b) Install the rear light assembly with the 3 nuts.
Torque:
7 N·m {71 kgf·cm, 62 in·lbf}
(c) Connect the connector.
2. INSTALL LUGGAGE COMPARTMENT DOOR COVER
Click here ![]()
Reassembly
REASSEMBLY
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR LIGHT CORD
(a) Install a new rear light packing to rear light cord as shown in the illustration. |
![]() |
(b) Engage the clamp.
(c) Connect the connector to install the rear light cord.
2. INSTALL REAR LIGHT GASKET
(a) Install the rear light gasket. |
![]() |
Removal
REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE LUGGAGE COMPARTMENT DOOR COVER
Click here ![]()
2. REMOVE REAR LIGHT ASSEMBLY
(a) Disconnect the connector. |
![]() |
(b) Remove the 3 nuts.
(c) Disengage the clip to remove the rear light assembly.








