Audi A3 Quiz
Body

Removing and Installing Side Moulding

In this manual: Body
Owner's Manual — 42Routine Care and Maintenance — 32Engine — 22Engine Cooling System — 9Ventilation, Heating and Air Conditioning Systems — 11Fuel System — 9Fuel Injection System — 4Diesel engine injection system — 5Exhaust System — 9Electronic Ignition and Fuel Injection Control System — 6Charging and Starting Systems — 12Manual transmission — 12Clutch and Drive Shafts — 6Brake System — 13Front Suspension — 5Rear Suspension — 6Steering — 7Body — 70Body Electrical Equipment — 37Wiring Diagrams — 35
~1min read

REMOVAL

PROCEDURE

1. Heat the moulding section by section with a heat gun and separate it.

2. Clean the bonding surfaces with gasoline, treat with silicone remover, and then dry. INSTALLATION

PROCEDURE

1. Heat the side moulding with hot air to a temperature of approximately +40°C.

2. Remove the protective film.

3. Install the moulding pivots into the holes of the door and rear fender. First press lightly, then press firmly.

Test yourself

A quick Audi A3 quiz: every answer comes with an explanation and a link to the manual page.